Say hello all

New user in this forum can introduce yourself here. Pictures of new UP Printer, fresh prints from UP Printer, and more.
Post Reply
Posts: 1
Joined: Wed Nov 14, 2018 3:52 am

Say hello all

Post by jackmarison93 » Wed Nov 14, 2018 3:53 am

Hi everyone, I'm Jackson newbie member here...

Owen Sparks aka Marksman
Posts: 610
Joined: Tue Mar 15, 2016 9:56 am

Re: Say hello all

Post by Owen Sparks aka Marksman » Thu Nov 15, 2018 7:44 am

Howdy and welcome.

What printer do you have and what do you use it for?

Owen S.

Posts: 2
Joined: Sun Nov 11, 2018 12:12 pm

Re: Say hello all

Post by Daniel » Wed Nov 21, 2018 1:23 pm

Hello everyone,

My name is Daniel, I am new to using Tiertime printers.

I recently bought an UP300 to print some small parts for a car I am restoring.

I have not had much time to use it yet, work has been getting in the way :)

I have attempted to print the calibration stl, but found the ABS print warping.

I am new to printing in ABS, previous machines I have owned were only really good for printing in PLA.

I hope after a manual bed leveling, ABS printing on the UP300 will not be a problem anymore.

I look forward to having the ability to reliably print ABS and flexible parts.

Posts: 101
Joined: Tue Oct 16, 2018 8:25 am

Re: Say hello all

Post by TiertimeBrook » Wed Nov 28, 2018 6:41 am

Hi Daniel.

UP300 have excellent ability with ABS printing, if found the warping problem, you can take follow steps to prevent it happening,
a.adjust the nozzle height mannually
b.try to close the wind tunnel on the extrude head to make the extruder a higher temperature
c, use the perf side of the print board.


Post Reply