Page 1 of 1

1 Mistake that every new 3D printerer does!

Posted: Fri Sep 16, 2016 6:52 am
by Manracle
As most or even all of the pros know, if you are printing W ABS, :) then you might want to close the insides of your 3D printer (if it's not yet then do so ;) ) because if you start printing and the bottom is colder then the one on top, the bottom one may then shrivel and un-stick from the top one and ruin your BIG BEAUTIFUL MASTERPIECE THAT WAS PRINTING FOR MORE THAN AN HOUR!!! :evil: