1 Mistake that every new 3D printerer does!

New user in this forum can introduce yourself here. Pictures of new UP Printer, fresh prints from UP Printer, and more.
Post Reply
Manracle
Posts: 1
Joined: Fri Sep 16, 2016 6:41 am

1 Mistake that every new 3D printerer does!

Post by Manracle » Fri Sep 16, 2016 6:52 am

As most or even all of the pros know, if you are printing W ABS, :) then you might want to close the insides of your 3D printer (if it's not yet then do so ;) ) because if you start printing and the bottom is colder then the one on top, the bottom one may then shrivel and un-stick from the top one and ruin your BIG BEAUTIFUL MASTERPIECE THAT WAS PRINTING FOR MORE THAN AN HOUR!!! :evil:

Post Reply