Hello from Poland

[Marcin]

Hi,
my name is Marcin and I'm starting my journey with 3D printing. Up! Plus2 is my first printer
Today I printed my first model - small at the beginning (photo in the attachment).

I know it is small (about 4 cm), but can it be smoother? I printed it with "Fine" quality , Z resolution 0,15 mm, Part angle 45, Support angle 50

[JWA]

Hi, I'm not an expert, but try printing with opened Wind Barrier - switch on extruder head.
It should help with printing details.
What filament are you printing? Is it UP's filament or something different?

[Marcin]

I don't know what filament it is (probably not original), because I got it from another user. Today I will check printing without wind barrier, and 0,2 mm Z resolution and we will see I will invest in better filament too. Thanks for advice.

[FallGuy]

Marcin

If you upload the model I could try and print and see if it is an issue of the model or printer setup. I do think JWA is right though, it looks like it may have been a little warm printing, you should try with the wind barrier open.

[JWA]

Sometimes even better filament will not help. It can have different melting temperature than UP filament. In UP Software default nozzle temp is around 260-270 C. A lot of ABS filament (non UP) you can buy has 230-240 C . But there is also for example Orbitech filament which has in theory 265 C melting temp. and works quit good with UP.