Hi from Sheffield, U.K.

New user in this forum can introduce yourself here. Pictures of new UP Printer, fresh prints from UP Printer, and more.
Post Reply
Macflame
Posts: 29
Joined: Mon Feb 09, 2015 11:22 pm
Location: Sheffield, U.K.

Hi from Sheffield, U.K.

Post by Macflame » Wed Feb 11, 2015 10:31 am

I have just purchased an Up! Mini from my favourite online auction site. It is minus the extruder, hot end, print plates, filament holder, tools and power supply so it is going to be a bit of a challenge. I have built a Prusa i3 so I have 3D printing experience and the means to print some parts for the Mini. Before I bought it I did a bit of research and found that someone had converted their Mini to take a Nema 17 motor, so I will try to do the same. Replacement parts are beyond my budget at the moment. Looking forward to reading and hopefully taking part in these forums.

Post Reply