Hi from NSW Australia

hobbymods · Post by **hobbymods** » Sat Feb 07, 2015 8:01 pm

Hi all,

I've had the UP! Plus for 2 years, and it's gone very well for me. It's done a lot of work.

I've just ordered 2 new UP! Plus 2's to replace it, and will overhaul the old one (new linear bearings/steppers as req'd) once they're in service.

I use mine to print mechanical/hobby parts in ABS, using an enclosure, and have always been impressed by the results of this printer.

Look forward to meeting you all.

wilsonj · Post by **wilsonj** » Wed Feb 11, 2015 3:03 am

Welcome aboard !

Hope the new bearings and steppers return the machine to near new. Then you will have 3 very capable machines.

Cheers
Jamie

hobbymods · Post by **hobbymods** » Thu Feb 12, 2015 12:26 am

Hi Jamie,

A few trails and tribulations lately, but I'm sure it will all work out.

Cheers,

Neil.

peterprinter · Post by **peterprinter** » Wed Nov 04, 2015 1:05 am

What enclosure are you using?

Hi from NSW Australia

Re: Hi from NSW Australia

Re: Hi from NSW Australia

Re: Hi from NSW Australia