Z level initialisation and clunking

Talk about anything.
Joined:Wed Jun 20, 2012 1:16 pm
Z level initialisation and clunking

Post by alistardean » Sat Apr 06, 2013 4:38 pm


Recently had to resolder a break in the platform heater cable (which needed a strip down of the platform and the axis cover). When reassembled, I get a clunking noise whenever it initialises (though the set-up wasn't moved at all). Now, when printing, each layer shifts by about 10-15mm across the platform (so only 3 layers on a biggish part's raft will print).

Any ideas what I've managed to screw up and how to fix it?



Post Reply