Page 1 of 1

Upbox auto calibration broken?!

Posted: Sat Aug 25, 2018 6:23 am
by logan_nzl
Hi all,

One minute my auto calibration is working fine then the next time I use it, the little arm doesn't pop down to measure height and the nozzle just starts pushing onto the build platform untill I hear the stepper motors skipping.
Does anyone know what has gone wrong? I'm so sick of this problematic printer! And it was very expensive which makes it such a let down.

Re: Upbox auto calibration broken?!

Posted: Sun Aug 26, 2018 12:51 pm
by Tiertime-Joseph
Hello,

Sorry for this is happening.

Could you please send an email to our support team support@tiertime.com? Along with the serial number of your machine. Our support team will be there to help you.

Thank you

Joseph