Page 1 of 1

Move error

Posted: Wed May 02, 2018 2:44 pm
by imane
Hello,

I have a Quant 3D printer, it works with UP plus 2 (firmware: V3.22).
The 3Dprinter doesn't work and it writes this message:
Move error.
Err code 002; X positive limit error.

Please, Can you help me to solve this problem?

Re: Move error

Posted: Fri May 04, 2018 12:42 am
by ricks01
when that happens, you can normally just turn off the printer and turn it back on and it's fine.

Re: Move error

Posted: Fri May 04, 2018 7:58 am
by brunningm
imane wrote:
Wed May 02, 2018 2:44 pm
Hello,

I have a Quant 3D printer, it works with UP plus 2 (firmware: V3.22).
The 3Dprinter doesn't work and it writes this message:
Move error.
Err code 002; X positive limit error.

Please, Can you help me to solve this problem?
Check the microswith for the X-axis, might have something stuck in it?