Move error

Talk about anything.
Post Reply
imane
Posts: 1
Joined: Wed May 02, 2018 1:30 pm

Move error

Post by imane » Wed May 02, 2018 2:44 pm

Hello,

I have a Quant 3D printer, it works with UP plus 2 (firmware: V3.22).
The 3Dprinter doesn't work and it writes this message:
Move error.
Err code 002; X positive limit error.

Please, Can you help me to solve this problem?

ricks01
Posts: 166
Joined: Wed Dec 30, 2015 6:07 pm

Re: Move error

Post by ricks01 » Fri May 04, 2018 12:42 am

when that happens, you can normally just turn off the printer and turn it back on and it's fine.

brunningm
Posts: 210
Joined: Fri Jul 21, 2017 9:44 am

Re: Move error

Post by brunningm » Fri May 04, 2018 7:58 am

imane wrote:
Wed May 02, 2018 2:44 pm
Hello,

I have a Quant 3D printer, it works with UP plus 2 (firmware: V3.22).
The 3Dprinter doesn't work and it writes this message:
Move error.
Err code 002; X positive limit error.

Please, Can you help me to solve this problem?
Check the microswith for the X-axis, might have something stuck in it?

Post Reply