V4 Printhead upgrade for the UP BOX

Talk about anything.
Post Reply
markbougourd
Posts: 8
Joined: Thu Jun 04, 2015 8:18 pm

V4 Printhead upgrade for the UP BOX

Post by markbougourd » Tue May 23, 2017 10:02 am

I have just fitted my V4 printhead upgrade to my original UP BOX and find its not getting to temperature.
It extrudes and withdraws at correct temperature 260° but when asked to print it struggles to get to temperature and will not print.
I have an upgraded CPU board as well. Print head gets to 260 then 270 ok but falls short of the 280 to print.
How can I change this as never had it with the old printhead.

Post Reply