Abs not sticking??? Help!!!
I have done everything, cleaned my bed, laid glue, set nozzle to 0.2mm , removed easy peel. And yet some.of my corners come.up after the 2nd later( after the initial pass). It gets to the first layer of the part and then I start to.see that it's popping off the bed
Re: Abs not sticking??? Help!!!
I should check:
1.- properly nozzle heigh
2- fan gate closed
3- the bed has reached the working temperature.
1.- properly nozzle heigh
2- fan gate closed
3- the bed has reached the working temperature.
Re: Abs not sticking??? Help!!!
imprenta3d wrote:I should check:
1.- properly nozzle heigh
2- fan gate closed
3- the bed has reached the working temperature.
4- Bed not level
- DrewPetitclerc
- Posts:581
- Joined:Sat Feb 12, 2011 7:39 am
- Location:Silicon Valley California
- Contact:
Re: Abs not sticking??? Help!!!
Try a thin coat of Elmer's glue stick, the purple water washable kind on the build plate.
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc
Re: Abs not sticking??? Help!!!
I had an awkward lifting corner that I accidentally fixed by switching the print to "fine".
I have no idea why this would make it stick, but stick it did.
I have no idea why this would make it stick, but stick it did.
- DrewPetitclerc
- Posts:581
- Joined:Sat Feb 12, 2011 7:39 am
- Location:Silicon Valley California
- Contact:
Re: Abs not sticking??? Help!!!
Slows the printhead down and allows a more pressed into build plate of the plastic.Robin wrote:I had an awkward lifting corner that I accidentally fixed by switching the print to "fine".
I have no idea why this would make it stick, but stick it did.
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc