After updating, custom filament are removed

Talk about anything.
Post Reply
moreupper
Posts: 30
Joined: Tue Jan 05, 2016 10:08 am

After updating, custom filament are removed

Post by moreupper » Thu May 11, 2017 9:22 am

After updating from 1.7.2.0 to 1.7.3.0 all my custom filament are removed :evil:

-Make it possible to save all the setup in a config file!!!

User avatar
DrewPetitclerc
Posts: 580
Joined: Sat Feb 12, 2011 7:39 am
Location: Silicon Valley California
Contact:

Re: After updating, custom filament are removed

Post by DrewPetitclerc » Thu May 11, 2017 9:41 pm

Whenever I'm making up configurations that are non standard in a software where I do not know for sure if they are "sticky" or backed up, I always grab a screen shot (alt+Print Screen) and paste it into a document for later review and comparison, this also means you can compare them offline if needed.
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc

Post Reply