BOX+ ABS warp: fan duct lever position?

Talk about anything.
Joined:Wed Jan 25, 2017 6:46 pm
BOX+ ABS warp: fan duct lever position?

Post by jverhagen » Fri Jan 27, 2017 12:37 pm


I got warping on a near full bed 4mm flat print even after decent calibration (I checked w the videos).

Box+ manual on p39 suggests to cool ABS less, and shows "Fan duct closed" w lever horizontal, or open w lever vertical.
In which position is the ABS cooled the least? It seems when horizontal - air comes out from the front iso toward the nozzle?
Sure feels that way but just checking -the manual is unclear to me here.

Thanks all!

Post Reply