I'm an UP Box and UP Mini owner so I thought I would share our most recent project with you as some of you might find it useful.
I have been using LokBuild in prototype form on my UP Box prints for a few months and it has some great advantages over other solutions.
One of the biggest differences between LokBuild and some other similar products is how forgiving LokBuild is when setting the nozzle height. We found others can be very difficult to get it dialled in correctly and if you get it wrong it can be almost impossible to remove the model from the surface. This was one of the reasons we developed LokBuild. It is much better in this regard and much easier to remove models after printing. We believe it is the easiest surface to use.
You can see the full Kickstarter campaign by following this link...
https://www.kickstarter.com/projects/st ... ld-surface
Talk about anything.
1 post •Page 1 of 1