Page 1 of 1

Fine mode Raft config?

Posted: Mon Jan 18, 2016 4:15 am
by mrgibbon
Hi All, peeling the raft away from part in normal mode is quite painful and time consuming for me.
BUT in Fine mode it peels right off.
Can anyone tell me the difference between the two and how I might be able to get the fine style raft when printing in normal or fast modes?
Thanks in advance!
G

Re: Fine mode Raft config?

Posted: Mon Jan 18, 2016 5:13 am
by ricks01
That is odd, I find the complete opposite - for me the raft is harder to remove when using "fine" mode.

Re: Fine mode Raft config?

Posted: Tue Jan 19, 2016 2:58 am
by Tiertime-Jason
Whenever the raft is difficult to remove, I decrease nozzle height value by 0.1-0.2mm. This usually improve the raft separation.