Not all copies are equal

Talk about anything.
Post Reply
Ian Smith
Joined:Thu May 09, 2013 5:46 am
Not all copies are equal

Post by Ian Smith » Fri Feb 14, 2014 8:36 am

I wanted 2 copies of a component, so I loaded it once then I added an additional copy via the UP right click "insert copy" function.
It wasn't a very complex item, as you can see from the attached pic, just an end cap with a cavity for a cover strip.
I printed the item on its back, so there was almost no support material required.
One of the items ( pretty sure it was the copy, but can't be certain) was printed with the cover strip cavity half filled with what looked like raft structure i.e not solid just an open criss-cross of material.
A subsequent single re-print of the item turned out OK

Any clues please?

Thank you

end cap.JPG
end cap.JPG (41.06KiB)Viewed 4054 times

User avatar
Joined:Wed May 16, 2012 12:24 pm
Location:Melbourne, Australia

Re: Not all copies are equal

Post by Lawrence » Fri Feb 14, 2014 9:33 am

looking at the image, that could be the much wanted new Upsized Up!Mega

Post Reply