Type of connector used on extruder fan?

Talk about anything.
Post Reply
goopyplastic
Posts: 42
Joined: Mon Jul 30, 2012 5:53 am

Type of connector used on extruder fan?

Post by goopyplastic » Fri Jan 31, 2014 7:42 pm

Anyone know what type of connector is used on the extruder fan?

Thanks!

twocycler
Posts: 59
Joined: Tue Aug 21, 2012 5:09 am

Re: Type of connector used on extruder fan?

Post by twocycler » Fri Jan 31, 2014 10:54 pm

It's a JST XH 3P connector.

goopyplastic
Posts: 42
Joined: Mon Jul 30, 2012 5:53 am

Re: Type of connector used on extruder fan?

Post by goopyplastic » Sat Feb 01, 2014 1:04 am

I believe XH is for the heater / thermocouple and the fan connector is smaller.

roller
Posts: 1622
Joined: Sat Oct 06, 2012 9:09 pm
Location: Brisbane, Australia

Re: Type of connector used on extruder fan?

Post by roller » Sat Feb 01, 2014 1:53 am

goopyplastic wrote:I believe XH is for the heater / thermocouple and the fan connector is smaller.
From memory (i'm out and about) they are all JST XH just the fan is 3P (3pin) as twocycler pointed out and the temp/heater is 4P (4pin)

goopyplastic
Posts: 42
Joined: Mon Jul 30, 2012 5:53 am

Re: Type of connector used on extruder fan?

Post by goopyplastic » Tue Feb 04, 2014 7:30 am

Is it possible that the Afinia has a different connector for fan? I would think they would be the same, here you can see the connector:

http://imgur.com/a/uys53

Definitely smaller than the XH connector next to it.

Post Reply