striation on surface of print

Talk about anything.
Joined:Fri Oct 04, 2013 11:34 pm
striation on surface of print

Post by ModelDog99 » Thu Nov 07, 2013 7:22 pm

Has anyone else had the problem of the surface of their prints being diagonally striated?
They are both from the same file. One on the left was printed after the one on the right.

Any thoughts?

I am currently printing a new file of a different object and I can already see that the striations are
present in the new part. It would seem that it is a software issue, so I downloaded a fresh version
of the software ( Up! Plus & Mini Software Ver 1.4 Mac ) and started a new print of the same object.

Also, the honeycomb is not printing correctly. It looks more like a scaffold structure. this may be
just a settings issue. I am printing hollow which is the same setting I have used before.

Any input would be appreciated.

IMG_0024.jpg (26.37KiB)Viewed 3539 times

Post Reply