They are both from the same file. One on the left was printed after the one on the right.
Any thoughts?
I am currently printing a new file of a different object and I can already see that the striations are
present in the new part. It would seem that it is a software issue, so I downloaded a fresh version
of the software ( Up! Plus & Mini Software Ver 1.4 Mac ) and started a new print of the same object.
Also, the honeycomb is not printing correctly. It looks more like a scaffold structure. this may be
just a settings issue. I am printing hollow which is the same setting I have used before.
Any input would be appreciated.
Thanx!
- IMG_0024.jpg (26.37KiB)Viewed 3388 times