Search found 26 matches

by Tiertime_Bryant
Fri Feb 17, 2017 2:49 pm
Forum: UP mini 2
Topic: grid wont show on the software
Replies: 2
Views: 4111

Re: grid wont show on the software

Hi,

Could you please let me know the model of your printer?and then the software you use is UP software or the UP Studio software?

Or,could you please feedback your questions to support@pp3dp.com?

Moreover,You are so woderful if you share your parts to me to knowand to slove the problem :D
by Tiertime_Bryant
Fri Feb 17, 2017 10:02 am
Forum: UP mini 2
Topic: UP mini touch screen stopped working
Replies: 5
Views: 7374

Re: UP mini touch screen stopped working

Hi,

Please try the following way:
by Tiertime_Bryant
Fri Feb 17, 2017 5:48 am
Forum: UP mini 2
Topic: Nozzle detect not working
Replies: 5
Views: 6731

Re: Nozzle detect not working

Hi,

I would like to konw that what kind of working condition which cause this problem? At the beginning of the printing or When you calibrate the nozzle height?
Or please refer to this to support@pp3dp.com?
by Tiertime_Bryant
Fri Feb 17, 2017 5:38 am
Forum: UP mini 2
Topic: UP mini touch screen stopped working
Replies: 5
Views: 7374

Re: UP mini touch screen stopped working

Hi,

Can you please describe the problem in detail?
The power cut or the screen is not responding?
by Tiertime_Bryant
Tue Dec 27, 2016 1:56 am
Forum: UP mini 2
Topic: Mini2 Internal light
Replies: 2
Views: 4516

Re: Mini2 Internal light

Hi,

You can keep the interior lights always open by opening the interior light switch on the screen.( Config--lighting)
Pay attention: After turn on the switch ,you'd better restart the UP mini2,and then you can see the light is working after initialization.

Pleasant experience!
by Tiertime_Bryant
Fri Dec 02, 2016 1:59 am
Forum: UP mini
Topic: Joggle Error
Replies: 2
Views: 4226

Re: Joggle Error

hi, You may get the error says "Joggle Error" with an error code 20 when you were printing a thin-wall model (the wall thickness below than about 1mm),there are 2ways: 1,While you transferring data files to the printer ,you'd better check the parameter named "thin-wall" on this position "print--pref...