Search found 8 matches

by gnomadix
Mon Dec 08, 2014 1:44 pm
Forum: UP Plus
Topic: Printing with NinjaFlex
Replies: 2
Views: 4404

Printing with NinjaFlex

HI there

I have a couple of UP! plus 2 printers
and a student is asking about printing with NinjaFlex with a temp range of 210-240

What would this require? would I have to modify the hardware
or is there another less complicated way

Many Thanks
Simon
by gnomadix
Wed Dec 03, 2014 3:45 pm
Forum: UP Plus
Topic: damaged feeder gear replacement?
Replies: 8
Views: 7924

damaged feeder gear replacement?

Dear All

I have a damaged extruder unit due to a blockage
the main issue is the feeder gear which has broken teeth

Does any one know if its possible to buy the replacement gear only?
(Denford would not replace so I had to buy whole unit)

And also how would I get it off the motor?

Many Thanks
Simon
by gnomadix
Fri Feb 14, 2014 1:20 pm
Forum: UP Software
Topic: Retraction Settings
Replies: 4
Views: 5708

Re: Retraction Settings

Thanks for your replies

I think the temp modding option sounds good
Please could you explain the best approach to start modding?


Many Thanks
Simon
by gnomadix
Thu Feb 13, 2014 12:27 pm
Forum: UP Software
Topic: Retraction Settings
Replies: 4
Views: 5708

Retraction Settings

HI there please could anyone tell me if the UP software includes a retraction setting like you would find in the Sli3er software for Reprap ? This is the setting I adjust when the deposition has bobbles and wispy bits so I as my UP! plus is bobbling a bit I wondered if there was an equivalent that m...
by gnomadix
Mon Dec 09, 2013 3:18 pm
Forum: UP Plus
Topic: Help/advice with Bed not raising
Replies: 1
Views: 3214

Help/advice with Bed not raising

Dear All, I was hoping to get some advice I was trying to tape down a curling print and accidentally put too much weight on the bed (but not a lot)and it dropped after that the bed would not lift more than 10-15mm when initialized Does any one have any experience of this: it is something I can fix? ...
by gnomadix
Wed Oct 30, 2013 7:47 am
Forum: General Discussion
Topic: What is Perfboard?
Replies: 5
Views: 5476

Re: What is Perfboard?

Thanks Juliadee and Doraemon

That's really helpful: I have an Up but I want
to use a big bit of Perfboard with my Reprap

Thanks
Simon
by gnomadix
Tue Oct 29, 2013 11:56 am
Forum: General Discussion
Topic: What is Perfboard?
Replies: 5
Views: 5476

Re: What is Perfboard?

Thanks Doraemon

that's very useful to know
by gnomadix
Mon Oct 28, 2013 5:00 pm
Forum: General Discussion
Topic: What is Perfboard?
Replies: 5
Views: 5476

What is Perfboard?

Dear all, I have recently been bought an UP! at work I found printing on to Perfboard a much better solution that using Kapton tape or sticky stuff Does anyone one know what Perfboard is and where it can be bought from? it seems to be probably PCB and has good heat retardent properties (teflon coate...