Hi OwenSparks, thanks for all your comments about GCODE

one question:

have you tried GCODE with UPBOX (non UPBOX+)(idle, without upgrade kit) only connected by usb?

thanks for sharing

Hi,

¿beta 1.9.0.3 change log?

Thank you

saludos, a ver si compartimos experiencias por aqui

buena señores, yo también tuve problemas de adhesión del raft a la pieza con las versiones 1.7.x, con la 1.6.1.2 me iba mejor. Con la 1.8.1.0 parece que vuelve a ir mejor. Saludos Lo que no he conseguido es imprimir en PLA, empieza a imprimir bien, pero a los 20 min o asi se atasca el filamento y se...

I have the problem with "easy peel" option enabled too

Same problem herre with 1.7.2.0....

hi guys:

I have installed up studio 1.6.10 beta an it crashes in windows 10....

I have uninstalled an reinstalled and it crash

¿any solution?

thanks

Up Studio does have different raft and slicing parameters, for this reason I still use Up software 2.18. The newer Up printers like Up Mini 2 and Up Box+ won't work with Up Studio because the layer height presets will not show up under Setup (the software will show ''please update your app''). Also...

snakesrules wrote:Hi there,
nice surprise to have to pay about 35$ more for custom taxes

me too

hi, one question

is possible to calibrate with up studio software? how?

thanks

I had the problem with all software versions.

My local distributor changed me the unit for a new one.

Great news, some questions:

Can we install it by ourself without warranty loose?
Are there Install instructions avaible?

Or do we have to contact to our local distributor to install it?

Thanks
Good job

4 prints after repair.....SAME ERROR...this unit is defective

Hi guys,

UPBOX was sent to the SAT and they repaired it. The problem was:

-FFC flat White cable replaced
-Hotend replaced

I have to congrat spanish SAT, exactly in 1 week I had my UPBOX repaired

Regards

you can have a cold joint on the small pcb on top of the print head, there can be a problem also on the track cable going from that board to the main pcb .. do a simple test, try extruding (you can do it without filament but better with) not printing and monitor temp, then wiggle cables on the top ...

I'm guessing that the NOZZLE TOO COOL error is likely a defective hot end, since the problem started after you replaced the extruder. Nozzle Too Cool is mostly likely to be caused by loose or broken wires to the hot end heater. Hi pleppik, the problem started before I replaced the extruder , with t...

UPDATED

Thanks tegregg, I will check it and test with stable support activated

SOLVED : -FFC flat White cable replaced -Hotend replaced Hi everybody, My upbox gives next error: https://s32.postimg.org/k7d82t83p/ERROR.jpg upbox start printing and it stops when it has printed the bed and basement of the model. It doen´t happend always, I have printed small models and no problem...

arhi wrote:https://nodna.de/Accessories-Consumables

thank you