Search found 8 matches

by rryerson
Fri Jan 20, 2017 3:20 pm
Forum: UP BOX & UP BOX+
Topic: printable spare parts
Replies: 7
Views: 5872

Re: printable spare parts

Why did you feel the need to post basically the same question twice?
by rryerson
Fri Jan 20, 2017 3:17 pm
Forum: General Discussion
Topic: UP! Filament???
Replies: 6
Views: 5389

Re: UP! Filament???

Why limit yourself?.... why don't you just use other 3d party filament? My Up mini, Up Plus 2 and UP Box print eSun ABS+ brilliantly and it's cheaper to boot... I have used FormFutura's EasyFil ABS too without issues...
by rryerson
Fri Aug 19, 2016 12:03 pm
Forum: UP BOX & UP BOX+
Topic: What Linear bearings for the UP Box
Replies: 1
Views: 2859

Re: What Linear bearings for the UP Box

***EDIT*** Sorry, I meant the bearing on the lower rod of the X axis....
by rryerson
Thu Aug 18, 2016 5:36 pm
Forum: UP BOX & UP BOX+
Topic: What Linear bearings for the UP Box
Replies: 1
Views: 2859

What Linear bearings for the UP Box

Anyone know what linear bearing (and where to get it) is used in the x and y axis of the UP Box?... I think one of my Y axis bearings (on the lower rail) has gone bad so I would like to replace it...

Thanks
Richard
by rryerson
Sun Aug 07, 2016 2:56 pm
Forum: UP mini
Topic: Heated bed problem after using UP Studio
Replies: 5
Views: 5446

Re: Heated bed problem after using UP Studio

Ok, I fixed the issue... re-installed the ROM/Firmware in my Up Mini and now all is well... Going to stick with using 2.18v Up Software for now....
by rryerson
Sun Aug 07, 2016 10:18 am
Forum: UP mini
Topic: Heated bed problem after using UP Studio
Replies: 5
Views: 5446

Heated bed problem after using UP Studio

So on a whim I installed UP Studio to use with my UP Mini and UP Box... Everything was working perfectly with my UP Mini until I tried using it with UP Studio. The heated bed would heat up initially and then shut down after the print began... So I went back to 2.18v of the Up Software but still the ...
by rryerson
Thu Jan 14, 2016 9:06 pm
Forum: UP BOX & UP BOX+
Topic: ABS+ ABS PLA
Replies: 7
Views: 8188

Re: ABS+ ABS PLA

Temperature... both bed and nozzle temp is set when you select the type of filament you are using... There is no other adjustment... There are hacks, but someone else will have to confirm if they work on the Up Box...
by rryerson
Tue Jan 05, 2016 2:09 pm
Forum: UP BOX & UP BOX+
Topic: Questions about the HEPA filter
Replies: 8
Views: 8354

Re: Questions about the HEPA filter

Any reason why you can't remove it and print without it? I mean we print now without one in the UP! Plus 2 and Mini... I am in a well ventilated area so to me it's just an additional cost to up keep...