Search found 4 matches

by Alexkara
Thu Apr 28, 2016 3:04 pm
Forum: UP BOX & UP BOX+
Topic: UP BOX Mod * run out of filament pause! :)
Replies: 35
Views: 51314

Re: UP BOX Mod * run out of filament pause! :)

Yes, I still have a couple left, please get in touch with me. Have come in a bit late into this forum, however, if any are available for sale I certainly would not hesitate in parting with some shekels for one. Not being electronically oriented and my soldering resembles an elephant with a brush in...
by Alexkara
Sun Jun 21, 2015 1:55 am
Forum: UP BOX & UP BOX+
Topic: UP BOX raft separation from model problems
Replies: 19
Views: 21593

Re: UP BOX raft separation from model problems

Hi, I use .15mm on my new BOX and I haven't had any major separation issue (touch wood/ABS). During calibration ensure your perfboard is properly seated. Manually check each corner by touch and pick the flattest board for calibration. When I first set up my BOX I had calibration issues due to imperf...
by Alexkara
Sun Jun 21, 2015 1:31 am
Forum: General Discussion
Topic: Size of cap for tight fitting
Replies: 3
Views: 3849

Re: Size of cap for tight fitting

Post a tad late, however, it may help in the furture. Usually when printing to specific dimensions, eg. circular infill/outfill (like your lids), I usually print from 1mm to 3mm "cut" of the "tube", test for fit and readjust/print/test till I'm happy. When the fit is what I want I then print the ful...
by Alexkara
Fri Jun 19, 2015 12:33 am
Forum: UP BOX & UP BOX+
Topic: Multiple 3D printers
Replies: 4
Views: 5210

Multiple 3D printers

The current software does not satisfactorily handle multiple printers. I was (still am) a proud owner of a UP Plus 2, I bit the bullet and bought the Box for the increased capacity. The new software (V2.15) will detect either the Up BOX or UP+2 but it gets confused and when you switch between the pr...