The moshop is not working at all. Where can I get files for the printable parts?
I have partially melted shroud and no way to replace it, because the designs I saved are for another extruder.
Just add them to the software without any additional hops!
So i replaced the bracket with printed one, also found that gear on the motor (4 on scheme) is slipping
Here is the video https://www.youtube.com/watch?v=mdozBt5NvB0
How do I fix that? What is the best way to remove the cotter on the shaft?
So i tried finding the slipping gears, but didn't find any. Not sure about 4, it is hard to check. But i found out that one of the brackets holding bearing on the shaft is broken, the one located between 2 and 3. Fount model by 3DWP https://www.up3d.com/community/memberlist.php?mode=viewprofile&u=12...
I think you have got an X axis shift. Print a tall square column. This might be from the back right gear slipping on the shaft. Found older thread and image below looks very much like what I had, lines are in groups, but not on all heights. http://3dprinting.com.au/images/Capture.JPG [/quote] What ...
Tried printing some more models in different places on the bed. Same shifting as on the hand. Files hand https://drive.google.com/file/d/0B2vEm5ed5QeJbHZQQThkTlg3bWs/view?usp=drivesdk Columns https://drive.google.com/file/d/0B2vEm5ed5QeJcGcwcWliYkJKQ2c/view?usp=drivesdk Hand printed as on first post...
Made some more test prints with height differences, in the middle is print from the first time. Now I am starting to think this may actually be slicing problem, as at first prints were from original stl, other two were imported and edited in Tinkercad, and they have same pattern on both of them, but...
Print head is secure, this is not it. I tied it with rubber bands and it is solid, but print was the same quality. Nothing is wrong with axis at my knowledge. I will do another prints, elevate and rotate model to get a clue.
2.18
I had similar problems with other files/models and thought it was because of high speed.
I Will add base to the model and print with same settings to see if this is Z-related.