Search found 3 matches

by TheGreatTom
Fri Mar 27, 2015 11:22 pm
Forum: UP Plus
Topic: Print not sticking to the bed
Replies: 9
Views: 15007

Re: Print not sticking to the bed

All have come with perfboards for the last couple of years. TheGreatTom, If it's clicking a lot your are too close ... raise your start height 0.1mm also make sure you calibrated when your bed and extruder were hot as they expand when heted making the gap too small if you calibrate when cold. I cal...
by TheGreatTom
Mon Mar 23, 2015 5:31 pm
Forum: UP Plus
Topic: Print not sticking to the bed
Replies: 9
Views: 15007

Re: Print not sticking to the bed

You should not have to use anything on your bed to make them stick. I've been printing on my Up Plus for a couple of years now and never use anything and don't have issues with prints lifting off except the occassioanl edge where warping will occur. In those cases only an enclosure to keep in the h...
by TheGreatTom
Sat Mar 21, 2015 8:22 pm
Forum: UP Plus
Topic: Print not sticking to the bed
Replies: 9
Views: 15007

Print not sticking to the bed

Hey there, I recently just bought an Up Plus 2 3D printer. But, for some reason my prints don't stick to the bed. I've tried using pritt stick, Hair Spray but nothing it seems to stick to it. When it unsticks I tend to get a warping effect on my prints making my 3d models uneven. Thank you for your ...