Search found 3 matches

by jmog
Fri May 09, 2014 3:43 am
Forum: Look! My Mod
Topic: Improvements I've made in the last year
Replies: 113
Views: 130372

Re: Improvements I've made in the last year

Added cooling air jet directly to extruder gear assembly to prevent softening of PLA filament too soon, PLA is worst case (heat is transferred from motor and extruder hot block) this will hopefully apply to new main board upgrade where stepper motors run at even higher temperatures. I currently run...
by jmog
Wed Apr 30, 2014 8:50 am
Forum: UP Plus
Topic: T-Glase printing
Replies: 7
Views: 6367

T-Glase printing

Hello, I was wondering if anyone has experimented printing the experimental material T-Glase in the Up! 2 printer. I have been trying to print with this material using the PLA settings, but I haven't managed to get a complete print yet, it always stops extruding in mid print. When I extrude the mate...
by jmog
Wed Apr 16, 2014 2:57 am
Forum: UP Plus
Topic: Extrusion stops mid-print
Replies: 12
Views: 29645

Re: Extrusion stops mid-print

Dear Andrew and Murat, Did you find any solution for this problem, I am facing the same problem. I contacted 3d printing systems and they told me I should try printing with a desk fan on, or look in third party accesories that will help adjust the printing temperature, but this could void the warran...